实现的模拟键盘代码，模拟ps2协议，可以与计算机相连实现键盘的功能，在keil c下开发的。-89s51 achieved through keyboard simulation code, simulation ps2 agreement with the computer keyboard connected to the functions of the c Keil under development
for the TI dm6446 platformBackground subtraction moduleMaintain a background model, which can distinguish background, foreground and theft/left pixelsShadow removal moduleDetect shadow regions in monochrome videosCamera shift detection and suppression moduleDetect of small camera shift, and suppress ...
This program accesses a SPI EEPROM using polled mode access. The F12x MCU is configured in 4-wire Single Master Mode, and the EEPROM is the only slave device connected to the SPI bus. The read/write operations are tailored to access a Microchip 4 kB EEPROM
All programs were tested using a breadboard containing a DS80C320,
32K Program memory, 32K Data memory, two 8-segment bar graph
LEDs/drivers, and an 11.0592 MHz crystal. The four 8-segment bar graph
LEDs/drivers were connected to ports 1, and 3 to display their
pins states.
// This program accesses a SPI EEPROM using polled mode access. The F06x MCU
// is configured in 4-wire Single Master Mode, and the EEPROM is the only
// slave device connected to the SPI bus. The read/write operations are
// tailored to access a Microchip 4 kB EEPROM 25LC320. The relevant hardware
...
// This program accesses a SPI EEPROM using polled mode access. The F06x MCU
// is configured in 4-wire Single Master Mode, and the EEPROM is the only
// slave device connected to the SPI bus. The read/write operations are
// tailored to access a Microchip 4 kB EEPROM 25LC320. The relevant hardware
...
This little Program allows you to send commands to the CardReader (CT-BCS) or to the Card itself.
First you will be ask to what Port the Reader is connected (0=COM1, 1=COM2).
Then the Class-Byte (CLA), Instruction-Byte (INS), Parameter 1 (P1), Parameter 2 (P2).
If wou don愒 want to send Parameter 3 ...
This will sample all 8 A/D-channels by the continous mode.
Each end of conversion will call an interrupt routine,
where the AD-channel is put to Port4[2..0]
and the upper nibble of the result is put to Port4[7..4].
Port 4 is connected to the user LEDs of the FlashCan100P Evaluation-Board
This demonstration models a flight control for the longitudinal motion of a Grumman Aerospace F-14 Tomcat. First order linear
approximations of the aircraft and actuator behavior are connected to an analog flight control design that uses the pilot s
stick pitch command as the set point for the air ...
