The objective is to set up SPI communication between VTI Technologies digital pressure sensor
component and an MCU of an application device ATMEGA16L. In this code example:
?The MCU is configured
?SCP1000-D01 is initialized and configured
?The high resolution measurement mode is activated
?Temperat ...
Enter the Matrix MS-DOS screensaver.
Sample of using bios functions (by int 10h) for text data output (monitor in the text mode) and keyboard input. Requires: Borland C++ 3.1 for DOS.
This document gives the code for programming a CC2500 transceiver using Altera Stratix FPGA. The FPGA and CC2500 are connected through SPI mode with the FPGA as the master and CC2500 as the slave.
This program requires the DSP2833x header files.
//
// This program requires an external I2C RTC connected to
// the I2C bus at address 0x6f.
//
// As supplied, this project is configured for "boot to SARAM"
// operation. The 2833x Boot Mode table is shown below.
// For information o ...
This program requires the DSP2833x header files.
//
// As supplied, this project is configured for "boot to SARAM"
// operation. The 2833x Boot Mode table is shown below.
// For information on configuring the boot mode of an eZdsp,
// please refer to the documentation included with the ...
This software is developed to provide ease with controller design. For PID control, options are given
to design and analyse the compensated and uncompensated system. You are free to choice among Proportional
PI, PD and PID mode of control. Both frequency and time domain characteristics can be ob ...
RS_latch using vhdl,
When using static gates as building blocks, the most fundamental latch is the simple SR latch, where S and R stand for set and reset. It can be constructed from a pair of cross-coupled NOR (Not OR) logic gates. The stored bit is present on the output marked Q.
Normally, in stor ...
