排序:上传时间 相关度 下载量 查看数

presented 139

按分类查找:

  • 基于单片机控制的二氧化碳浓度测试计

    基于单片机控制的二氧化碳浓度测试计:基于CDM4161二氧化碳气体浓度测试模块以及ATtiny26单片机,提出了一种二氧化碳浓度测试计的设计方案。该方案具有硬件电路简单、成本低、可靠性高、测量准确等优点,具有较高的实用价值。 Abstract: Abstract:A desigh scheme of CO2 concentration meter based on CDM4161carbon dioxid ...

    /dl/31324.html

    标签: 单片机控制 二氧化碳 测试

    上传时间: 2013-11-14

    上传用户:zjwangyichao

  • Emulating a synchronous serial

    The C500 microcontroller family usually provides only one on-chip synchronous serialchannel (SSC). If a second SSC is required, an emulation of the missing interface mayhelp to avoid an external hardware solution with additional electronic components.The solution presented in this paper and in the a ...

    /dl/31365.html

    标签: synchronous Emulating serial

    上传时间: 2014-01-31

    上传用户:z1191176801

  • 使用软件程序仿真C500微控制器系列SSC(同步串行通道)功

    The solution presented in this paper and in the attached source files emulates the mostimportant SSC functions by using SW routines implemented in C. The code is focused onthe SAB C513, but will fit to all C500 derivatives.Beyond the low level software drivers a test shell is delivered. This shell a ...

    /dl/31367.html

    标签: C500 SSC 软件 程序

    上传时间: 2013-11-24

    上传用户:363186

  • I2C slave routines for the 87L

    The 87LPC76X Microcontroller combines in a small package thebenefits of a high-performance microcontroller with on-boardhardware supporting the Inter-Integrated Circuit (I2C) bus interface.The 87LPC76X can be programmed both as an I2C bus master, aslave, or both. An overview of the I2C bus and descr ...

    /dl/31386.html

    标签: routines slave I2C 87L

    上传时间: 2013-11-19

    上传用户:shirleyYim

  • 87LPC76X的IIC从程序

    Presents short and simple I2C software routines that support onlyslave (rather than master or master & slave) operation and an ASMdemonstration program. The slave-only software in this app notecomplements the master mode software presented in AN464, Usingthe 87LPC76X microcontroller as an I2C bus ma ...

    /dl/31389.html

    标签: 76X LPC IIC 87

    上传时间: 2013-11-22

    上传用户:1039312764

  • 基于P87C591的CAN总线系统智能节点设计

    基于P87 C591的CAN总线系统智能节点设计Design of CAN System Intelligent Node Based on P87C591 给出了基于带CAN控制器的单片8位微控制器P87C591的智能节点的硬件电路及软件结构,详细介绍了设计中的难点及实现过程中应注意的问题。关键词:CAN总线;智能节点 Abstract:A h ardc ircuita nds oftw arec onfigurationo fth e ...

    /dl/31390.html

    标签: P87C591 CAN 总线系统 智能节点

    上传时间: 2013-10-30

    上传用户:xymbian

  • 51编程指南--MCSÉ-51 Program

    MCSÉ-51 Programmer's Guide and Instruction Set The information presented in this chapter is collected from the MCSÉ-51 Architectural Overview and the HardwareDescription of the 8051, 8052 and 80C51 chapters of this book. The material has been selected and rearranged toform a quick and ...

    /dl/31425.html

    标签: Program Eacute MCS 51

    上传时间: 2013-11-13

    上传用户:hj_18

  • Employing a Single-Chip Transceiver in Femtocell Base-Station Applications

    Abstract: This application note discusses the development and deployment of 3G cellular femtocell base stations. The technicalchallenges for last-mile residential connectivity and adding system capacity in dense urban environments are discussed, with 3Gfemtocell base stations as a cost-effective s ...

    /dl/32535.html

    标签: Base-Station Applications Single-Chip Transceiver

    上传时间: 2013-11-07

    上传用户:songrui

  • 基于FPGA的光纤光栅解调系统的研究

     波长信号的解调是实现光纤光栅传感网络的关键,基于现有的光纤光栅传感器解调方法,提出一种基于FPGA的双匹配光纤光栅解调方法,此系统是一种高速率、高精度、低成本的解调系统,并且通过引入双匹配光栅有效地克服了双值问题同时扩大了检测范围。分析了光纤光栅的测温原理并给出了该方案软硬件设计,综合考虑系统的解 ...

    /dl/32659.html

    标签: FPGA 光纤光栅 解调系统

    上传时间: 2014-07-24

    上传用户:caiguoqing

  • VxWorks6.x中的ML403嵌入式开发平台

    The use of the Wind River VxWorks Real-Time Operating System (RTOS) on Virtex™-4embedded PowerPC™ processors continues to be a popular choice for high performanceFPGA designs. The introduction of the Wind River Workbench design environment has enableda new and easier way for designers ...

    /dl/35821.html

    标签: VxWorks 403 ML 嵌入式

    上传时间: 2013-10-26

    上传用户:agent