This example program shows how to configure and use the A/D Converter of the following microcontroller:
STMicroelectronics ST10F166
After configuring the A/D, the program reads the A/D result and outputs the converted value using the serial port.
To run this program...
Build the project (Project ...
Contents at a Glance
Introduction 1
PART I INSTALLATION AND CONFIGURATION 5
Hour 1 Preparing to Install Linux 7
2 Installing Linux 23
3 Post-Installation Issues 41
PART II LEARNING LINUX BASICS 67
Hour 4 Reading and Navigation Commands 69
5 Manipulation and Searching Commands 93
6 Using the Shell 11 ...
This sample displays a basic integer calculator powered
by the 8051 microcontroller. Although Keil C51 has a
full floating point math library the evaluation version
is restricted to 2k of object code, so we have constrained
this sample to integer maths in order to fit within this limit.
The progra ...
MySQL claims to be the world s most popular open source database, and with good
reason. It is free, runs on a wide variety of platforms, is relatively simple, easy to
configure and performs well even under significant load. By comparison to some other
popular database management systems, configur ...
Unix Unleashed, Third Edition is written with the power user and system administrator in mind. This book will help the reader understand the nuances of the major Unix variants including SVR4, HP-UX, Solaris, AIX, BSD, IRIX, SunOS, and Linux. It will help the reader decide which Unix shell works best ...
1. It is located in the root directory - SecurityBuilderDemo.exe. Leave password box blank and click on Security button
in order to Add/Remove users and set user rights. Once you entered Security dialog you may select your Supervisor password.
2. Click OK when finished configuring users. Don t forg ...
This program requires the DSP2833x header files.
//
// This program requires an external I2C RTC connected to
// the I2C bus at address 0x6f.
//
// As supplied, this project is configured for "boot to SARAM"
// operation. The 2833x Boot Mode table is shown below.
// For information o ...
This program requires the DSP2833x header files.
//
// As supplied, this project is configured for "boot to SARAM"
// operation. The 2833x Boot Mode table is shown below.
// For information on configuring the boot mode of an eZdsp,
// please refer to the documentation included with the ...
Installation of PelcoNet NET300 requires support from your network
administrator. Contact your administrator to assist with STEP 2A –
Configuring PelcoNet Using HyperTerminal. Write down the following
information from your network administrator:
