Description: This program demonstrates a half-duplex 9600-baud UART using
// Timer_A3 using no XTAL and an external resistor for DCO ROSC. DCO used for
// TACLK UART baud generation. The program will wait in LPM4, echoing back
// a received character using 8N1 protocol. On valid RX character, the
// ...
Artistic Style is a reindenter and reformatter of C, C++, C# and Java source code.
When indenting source code, we as programmers have a tendency to use both spaces and tab characters to create the wanted indentation. Moreover, some editors by default insert spaces instead of tabs when pressing the ...
Project file for MS Visual C++ 6.0.
Requires GLUT DLL (www.opengl.org)
Adjust program constants in Landscape.h and Utility.cpp.
MAPS:
Default map is read from HeghtXXX.raw where XXX is the MAP_SIZE
(as defined in Landscape.h). If this map is not found, the program
attempts to open "Map.ved", a Tre ...
Full compliance with the USB Specification v1.1 and USB CDC v1.1
Support the RS232 Serial interface
Support automatic handshake mode
Support Remote wake-up and power management
256 bytes buffer each for upstream and downstream data flow
Support default ROM or external EEPROM for device configur ...
MSP-FET430P410 Demo - Timer_A Toggle P5.1, CCR0 Contmode ISR, DCO SMCLK
Description Toggle P5.1 using using software and TA_0 ISR. Toggle rate is
set at 50000 DCO/SMCLK cycles. Default DCO frequency used for TACLK.
Durring the TA_0 ISR P5.1 is toggled and 50000 clock cycles are added to CCR0. TA_ ...
D169 Demo - DMA0 Repeated Burst to-from RAM, Software Trigger
Description A 32 byte block from 220h-240h is transfered to 240h-260h
using DMA0 in a burst block using software DMAREQ trigger.
After each transfer, source, destination and DMA size are
reset to inital software setting because DMA tran ...
MSP-FET430P140 Demo - USART0, SPI Interface to HC165/164 Shift Registers
Description: Demonstrate USART0 in two-way SPI mode. Data are read from
an HC165, and same data written back to the HC164.
ACLK = n/a MCLK = SMCLK = default DCO = UCLK0 = DCO/2
* USART0 control bits are in different SFR s from ...
this directory
contains the following:
* The acdc algorithm for finding the
approximate general (non-orthogonal)
joint diagonalizer (in the direct Least Squares sense) of a set of Hermitian matrices.
[acdc.m]
* The acdc algorithm for finding the
same for a set of Symmetric matrices.
[acdc_s ...
