Use the verilog language write a MIPS CPU code, and have additional instruction, for example: selection sort instruction.
The code has contain combination circuit and sequenial circuit.
CPU have contain ALU, ADD, ALU_CONTROL, DATA_MEMORY, INST_MEMORY, REGISTER, PC, and TESTBRANCH.
he LPC932 can be used to create a Pulse Width Modulated PWM signal. That s an analog signal, with only 2 discrete levels, for example 0V and 5V and a constant period. The current value of this signal at a certain poiTnt of time is proportional to its Duty Cycle. That s the High Time during one perio ...
t transistor has the characteristics of components of the sensor real-time measurement of voltage and current signals through, obtained quality factor correction circuit for the feedback and the feedback time, IBM used the feedback field effect transistor implementation, in order to achieve quality ...
A system simulation environment in Matlab/Simulink of RFID is constructed in this paper.
Special attention is emphasized on the analog/RF circuit.Negative effects are concerned in the system
model,such as phase noise of the local oscillator,TX-RX coupling,reflection of the environment,
AWGN noise,DC ...
The aim of this book is to provide the reader with a thorough grounding in the General Packet Radio Service – GPRS.The introduction contains a basic review of GSM to ensure that the reader is clear on the main aspects of
circuit switched technology, as this will make the differences and advantages ...
Squaring circuits are an important building block for impulse-radio UWB non-coherent receivers. This work proposes a squarer, based on the quadratic law of saturated transistors. Such a circuit has already been proposed for lower frequency applications, therefore this work focuses on the extension t ...
