Description: This program demonstrates a half-duplex 9600-baud UART using
// Timer_A3 using no XTAL and an external resistor for DCO ROSC. DCO used for
// TACLK UART baud generation. The program will wait in LPM4, echoing back
// a received character using 8N1 protocol. On valid RX character, the
// ...
*** *** *** *** *** *** *****
** Two wire/I2C Bus READ/WRITE Sample Routines of Microchip s
** 24Cxx / 85Cxx serial CMOS EEPROM interfacing to a
** PIC16C54 8-bit CMOS single chip microcomputer
** Revsied Version 2.0 (4/2/92).
**
** Part use = PIC16C54-XT/JW
** Note: 1) All timings are base ...
The PW5410B is a low noise, constant frequency (1.2MHz) switched capacitor voltage doubler. Itproduces a regulated output voltage from 1.8V to 5V input with up to 100mA of output current. Lowexternal parts count (one flying capacitor and two small bypass capacitors at VIN and VOUT) makethe PW5410B i ...
The PW5410A is a low noise, constant frequency (1.2MHz) switched capacitor voltage doubler. Itproduces a regulated output voltage from 2.7V to 5V input with up to 250mA of output current. Lowexternal parts count (one flying capacitor and two small bypass capacitors at VIN and VOUT) makethe PW5410A i ...
The PW2053 is a high-efficiency monolithic synchronous buck regulator using a constantfrequency, current mode architecture. The device is available in an adjustable version. Supply currentwith no load is 40uA and drops to <1uA in shutdown. The 2.5V to 5.5V input voltage range makesthe PW2053 ideally ...
