// $Id: beta.CC2420Radio.ieee.802.15.4.MLME.MLME_POLL.nc.source,v 1.1 2004/03/09 01:13:28 jpolastre Exp $ /* tab:4 * "Copyright (c) 2000-2003 The Regents of the University of California. * All rights reserved. * * Permission to use, copy, modify, and distribute this software and its * documentation for any purpose, without fee, and without written agreement is * hereby granted, provided that the above copyright notice, the following * two paragraphs and the author appear in all copies of this software. * * IN NO EVENT SHALL THE UNIVERSITY OF CALIFORNIA BE LIABLE TO ANY PARTY FOR * DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT * OF THE USE OF THIS SOFTWARE AND ITS DOCUMENTATION, EVEN IF THE UNIVERSITY OF * CALIFORNIA HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. * * THE UNIVERSITY OF CALIFORNIA SPECIFICALLY DISCLAIMS ANY WARRANTIES, * INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY * AND FITNESS FOR A PARTICULAR PURPOSE. THE SOFTWARE PROVIDED HEREUNDER IS * ON AN "AS IS" BASIS, AND THE UNIVERSITY OF CALIFORNIA HAS NO OBLIGATION TO * PROVIDE MAINTENANCE, SUPPORT, UPDATES, ENHANCEMENTS, OR MODIFICATIONS." * * Copyright (c) 2002-2003 Intel Corporation * All rights reserved. * * This file is distributed under the terms in the attached INTEL-LICENSE * file. If you do not find these files, copies can be found by writing to * Intel Research Berkeley, 2150 Shattuck Avenue, Suite 1300, Berkeley, CA, * 94704. Attention: Intel License Inquiry. */ /* * Authors: Joe Polastre */ includes IEEE802154; /** * The MLME-SAP polling primitives define how to request data from a * coordinator. * * @author Joe Polastre */ interface MLME_POLL { /** * Prompts the device to request data from the coordinator. * See page 106 of the IEEE 802.15.4 specification. * * @param CoordAddrMode The addressing mode of the coordinator to which * the poll is intended * @param CoordPANId The PAN identifier of the coordinator to which the * poll is intended * @param CoordAddress The address of the coordinator to which the * poll is intended * @param SecurityEnable TRUE if security is enabled for this transfer */ command void request ( uint8_t CoordAddrMode, uint16_t CoordPANId, uint8_t* CoordAddress, bool SecurityEnable ); /** * Reports the results of a request to poll the coordinator for data * * @param status The status of the data request */ event void confirm ( IEEE_status status ); }
