An OSS/Lite Driver for the ESS Maestro3 family of sound chips Zach Brown, January 2001 Driver Status and Availability ------------------------------ The most recent version of this driver will hopefully always be available at http://www.zabbo.net/maestro3/ I will try and maintain the most recent stable version of the driver in both the stable and development kernel lines. Historically I've sucked pretty hard at actually doing that, however. ESS Maestro3 Chip Family ----------------------- The 'Maestro3' is much like the Maestro2 chip. The noted improvement is the removal of the silicon in the '2' that did PCM mixing. All that work is now done through a custom DSP called the ASSP, the Asynchronus Specific Signal Processor. The 'Allegro' is a baby version of the Maestro3. I'm not entirely clear on the extent of the differences, but the driver supports them both :) The 'Allegro' shows up as PCI ID 0x1988 and the Maestro3 as 0x1998, both under ESS's vendor ID of 0x125D. The Maestro3 can also show up as 0x199a when hardware strapping is used. The chip can also act as a multi function device. The modem IDs follow the audio multimedia device IDs. (so the modem part of an Allegro shows up as 0x1989) Driver OSS Behavior -------------------- This OSS driver exports /dev/mixer and /dev/dsp to applications, which mostly adhere to the OSS spec. This driver doesn't register itself with /dev/sndstat, so don't expect information to appear there. The /dev/dsp device exported behaves as expected. Playback is supported in all the various lovely formats. 8/16bit stereo/mono from 8khz to 48khz, with both read()/write(), and mmap(). /dev/mixer is an interface to the AC'97 codec on the Maestro3. It is worth noting that there are a variety of AC'97s that can be wired to the Maestro3. Which is used is entirely up to the hardware implementor. This should only be visible to the user by the presence, or lack, of 'Bass' and 'Treble' sliders in the mixer. Not all AC'97s have them. The Allegro has an onchip AC'97. The driver doesn't support MIDI or FM playback at the moment. Compiling and Installing ------------------------ With the drivers inclusion into the kernel, compiling and installing is the same as most OSS/Lite modular sound drivers. Compilation of the driver is enabled through the CONFIG_SOUND_MAESTRO3 variable in the config system. It may be modular or statically linked. If it is modular it should be installed with the rest of the modules for the kernel on the system. Typically this will be in /lib/modules/ somewhere. 'alias sound-slot-0 maestro3' should also be added to your module configs (typically /etc/modules.conf) if you're using modular OSS/Lite sound and want to default to using a maestro3 chip. There are very few options to the driver. One is 'debug' which will tell the driver to print minimal debugging information as it runs. This can be collected with 'dmesg' or through the klogd daemon. The other is 'external_amp', which tells the driver to attempt to enable an external amplifier. This defaults to '1', you can tell the driver not to bother enabling such an amplifier by setting it to '0'. Power Management ---------------- This driver has a minimal understanding of PCI Power Management. It will try and power down the chip when the system is suspended, and power it up with it is resumed. It will also try and power down the chip when the machine is shut down.
