Algorithm Festel. Programs read from file to array byte[]. key block = 64 data block = 128 if use classis Festel data block = 256 if use modification Festel
资源简介:Algorithm Festel. Programs read from file to array byte[]. key block = 64 data block = 128 if use classis Festel data block = 256 if use modification Festel
上传时间: 2014-12-05
上传用户:kikye
资源简介:This file contains routines to write to and read from the I2C bus using the GPIO pins of the CS5530.
上传时间: 2014-01-21
上传用户:zaizaibang
资源简介:ARM下 Implement matrix multiplication of 2 square matrices, with data read from an input file and printed both to the console and to an output file. • Assume a file with correct data (no garbage, characters, etc.). • you must ch...
上传时间: 2014-08-30
上传用户:dsgkjgkjg
资源简介:This designs uses a Nios II system to demonstrate how to read from the SD card. The software reads WAV files from the SD card and plays it through the LINE OUT line. Simply put a SD card into the slot on the board and connect some speakers ...
上传时间: 2015-10-26
上传用户:lizhen9880
资源简介:converting tool from hex file to text file
上传时间: 2014-01-22
上传用户:czl10052678
资源简介:// This program demonstrates how to configure the C8051F060 to write to and read // from the UART interface. The program reads a word using the UART0 interrupts // and outputs that word to the screen, with all characters in uppercase
上传时间: 2013-12-23
上传用户:hopy
资源简介:A clock writing by Verilog which can count from 00:00 to 23:59. With a C file to see the simulation results. A co-design example of C and Verilog.
上传时间: 2016-10-12
上传用户:王者A
资源简介:PRINCIPLE: The UVE algorithm detects and eliminates from a PLS model (including from 1 to A components) those variables that do not carry any relevant information to model Y. The criterion used to trace the un-informative variables is the r...
上传时间: 2016-11-27
上传用户:凌云御清风
资源简介:Matlab file to read letter
上传时间: 2013-12-25
上传用户:hwl453472107
资源简介:Read nmea file and send to com port. you can easly simulate the gps application
上传时间: 2013-12-23
上传用户:372825274