Bootloading the TMS320VC5506/C5507/C5509 A digital signal processor (DSP)
through the on-chip universal serial bus (USB) peripheral is part of the standard
bootloader provided on the device. This document describes the procedures for
physically connecting the DSP to a USB host, invoking the USB boot ...
Development tools for the AT91CAP9-DK.Examples on how to use the AT91CAP9-DK features and peripherals, as well as more complex demonstration applications.
This tutorial presents an introduction to Altera’s Nios R
II processor, which is a soft processor that can be in-
stantiated on an Altera FPGA device. It describes the basic architecture of Nios II and its instruction set. The NiosII processor and its associated memory and peripheral components ar ...
This application report discusses the design of non-invasive optical plethysmography
also called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). The
pulsoximeter consists of a peripheral probe combined with the MCU displaying the
oxygen saturation and pulse rate on a LCD glass. The same ...
The SL11RIDE is a low cost, high speed Universal Serial Bus RISC based Controller board. It contains a
16-bit RISC processor with built in SL11RIDE ROM to greatly reduce firmware development efforts. Its
serial flash EEPROM interface offers low cost storage for USB device configuration and customer ...
Wishbone to LPC (Low-Pin Count) Bridge, includes master and slave modules. Supports 8-bit I/O Read and Write cycles, 8-bit Memory Read/Write cycles, DMA cycles, and up to 32-bit Firmware memory read/write cycles. Serial IRQ support is also provided.
None of this has been tested (yet) with a third-p ...
