# # Ftape configuration # dep_tristate ' Zftape, the VFS interface' CONFIG_ZFTAPE $CONFIG_FTAPE if [ "$CONFIG_ZFTAPE" != "n" ]; then int ' Default block size' CONFIG_ZFT_DFLT_BLK_SZ 10240 comment ' The compressor will be built as a module only!' define_tristate CONFIG_ZFT_COMPRESSOR m fi if [ "$CONFIG_EXPERIMENTAL" = "y" ]; then int ' Number of ftape buffers (EXPERIMENTAL)' CONFIG_FT_NR_BUFFERS 3 fi if [ "$CONFIG_PROC_FS" = "y" ]; then bool ' Enable procfs status report (+2kb)' CONFIG_FT_PROC_FS fi choice 'Debugging output' \ "Normal CONFIG_FT_NORMAL_DEBUG \ Excessive CONFIG_FT_FULL_DEBUG \ Reduced CONFIG_FT_NO_TRACE \ None CONFIG_FT_NO_TRACE_AT_ALL" Normal comment 'Hardware configuration' choice 'Floppy tape controllers' \ "Standard CONFIG_FT_STD_FDC \ MACH-2 CONFIG_FT_MACH2 \ FC-10/FC-20 CONFIG_FT_PROBE_FC10 \ Alt/82078 CONFIG_FT_ALT_FDC" Standard if [ "$CONFIG_FT_STD_FDC" != "y" ]; then comment ' Consult the manuals of your tape drive for the correct settings!' hex ' IO base of the floppy disk controller' CONFIG_FT_FDC_BASE 0 int ' IRQ channel of the floppy disk controller' CONFIG_FT_FDC_IRQ 0 int ' DMA channel of the floppy disk controller' CONFIG_FT_FDC_DMA 0 fi if [ "$CONFIG_EXPERIMENTAL" = "y" ]; then int ' Default FIFO threshold (EXPERIMENTAL)' CONFIG_FT_FDC_THR 8 int ' Maximal data rate to use (EXPERIMENTAL)' CONFIG_FT_FDC_MAX_RATE 2000 fi if [ "$CONFIG_ALPHA" = "y" ]; then int ' CPU clock frequency of your DEC Alpha' CONFIG_FT_ALPHA_CLOCK 0 else define_int CONFIG_FT_ALPHA_CLOCK 0 fi
