// $Id: I2CC.nc,v 1.1.10.5 2003/08/26 09:08:16 cssharp Exp $ /* tab:4 * "Copyright (c) 2000-2003 The Regents of the University of California. * All rights reserved. * * Permission to use, copy, modify, and distribute this software and its * documentation for any purpose, without fee, and without written agreement is * hereby granted, provided that the above copyright notice, the following * two paragraphs and the author appear in all copies of this software. * * IN NO EVENT SHALL THE UNIVERSITY OF CALIFORNIA BE LIABLE TO ANY PARTY FOR * DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT * OF THE USE OF THIS SOFTWARE AND ITS DOCUMENTATION, EVEN IF THE UNIVERSITY OF * CALIFORNIA HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. * * THE UNIVERSITY OF CALIFORNIA SPECIFICALLY DISCLAIMS ANY WARRANTIES, * INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY * AND FITNESS FOR A PARTICULAR PURPOSE. THE SOFTWARE PROVIDED HEREUNDER IS * ON AN "AS IS" BASIS, AND THE UNIVERSITY OF CALIFORNIA HAS NO OBLIGATION TO * PROVIDE MAINTENANCE, SUPPORT, UPDATES, ENHANCEMENTS, OR MODIFICATIONS." * * Copyright (c) 2002-2003 Intel Corporation * All rights reserved. * * This file is distributed under the terms in the attached INTEL-LICENSE * file. If you do not find these files, copies can be found by writing to * Intel Research Berkeley, 2150 Shattuck Avenue, Suite 1300, Berkeley, CA, * 94704. Attention: Intel License Inquiry. */ /* * * Authors: Phil Buonadonna, Joe Polastre, Rob Szewczyk * Date last modified: $Id: I2CC.nc,v 1.1.10.5 2003/08/26 09:08:16 cssharp Exp $ * * Note: Modify this configuration file to choose between software or hardware * based I2C. */ /* Uncomment line below to enable Hardware based I2C on the mica128 */ //#define HARDWARE_I2C /** * @author Phil Buonadonna * @author Joe Polastre * @author Rob Szewczyk */ configuration I2CC { provides { interface StdControl; interface I2C; } } implementation { #ifdef HARDWARE_I2C components HPLI2CM; StdControl = HPLI2CM; I2C = HPLI2CM; #else components I2CM; StdControl = I2CM; I2C = I2CM; #endif }
